Skip to content

Cutting Optimizer for Bars and Sheets

Enter the pieces you need to cut (length and quantity, or width, height and quantity) and the size of the bars or sheets you buy. The tool lays the pieces out, allows for the saw kerf and the end trim, and shows how many bars or sheets to buy and how much is left over.

Stock available (bars you can buy or already own)

Leave empty for a bar you buy as needed; a quantity means offcuts you already own: they are used first, at no cost.

Pieces to cut

To buy
5
Used
82 %
Waste
18 %
Lowest possible
5
No plan can use fewer.

Cutting plan

  1. 2 × A 240 + A 240 + C 90 — Offcut: 29.4 cm

    24024090
  2. 1 × A 240 + B 180 + C 90 — Offcut: 89.4 cm

    24018090
  3. 1 × B 180 + B 180 + B 180 — Offcut: 59.4 cm

    180180180
  4. 1 × C 90 + C 90 + C 90 — Offcut: 329.4 cm

    909090

A heuristic: a good, valid plan, not a proof of the optimum. Check it against your saw and your material before cutting.

Results are provided for information. Check tax rates and legal requirements that apply to you.

How to use it

  1. Choose bars (one dimension) or sheets (two dimensions).
  2. Enter the stock length or size, the saw kerf and the trim.
  3. List the pieces: length (or width and height) and quantity.
  4. Read the number to buy, the waste and the cutting plan, bar by bar or sheet by sheet.

Examples

6 m bars, 3 mm kerf: 5 pieces of 2.40 m, 4 of 1.80 m, 6 of 0.90 m

5 bars to buy (no plan can do with fewer than 5), 82 % of the bought length used.

Frequently asked questions

Is the plan the best possible?

It is a good, valid plan found by proven heuristics, not a proof of the optimum. The tool also shows the lowest number of bars or sheets any plan could reach, so you can see how close it is.

How are the kerf and the trim handled?

The kerf is lost between two neighbouring pieces and the trim is cut off at each end of a bar or around a sheet; both are taken from the usable length.

Can pieces be turned in a sheet?

Yes, unless you tell the tool the material has a grain or a pattern that must keep its direction.

Guides to go further

BUILIVA

How to count aluminium joinery

Frame and leaf profiles, glass, door sheets, shutter slats, extruded weight and cladding: the method to order, with an example.

Next step

BUILIVA

Rebar: Weight and Bending

Rebar weight from a length or cut pieces, plus cut length and weight of stirrups, L, U and straight bars, with hooks, waste and 12 m bars to buy.

BUILIVA

Aluminium Joinery Quantities

Doors (WC, stainless, steel, fire), windows, french windows, shutters and curtains, extruded profiles and cladding in aluminium, from your dimensions.

BUILIVA

Wood Joinery Quantities

Wooden doors, windows and boards (decking, cladding): timber volume and lengths, board sheets and glass, from your dimensions.